Phison mSATA RAID 0 SSD (SSE256GTTCR-S80)

Post Reply
lcoughey
Site Admin
Posts: 311
Joined: Thu Jan 08, 2015 7:23 pm

Phison mSATA RAID 0 SSD (SSE256GTTCR-S80)

Post by lcoughey » Thu Aug 10, 2017 12:58 pm

I haven't seen RAID 0 SSD for quite some time and all that I did see were ZIF/LIF connections. This time around, I've got an mSATA dual 128GB (total 256GB) SSD. I'm kind of hoping to save some time and my client some money by hoping that someone here has already laid out the ground work and can confirm the correct pinout for the secondary SATA line.

Channel 0 (based on mSATA standard layouts)
33 - C1 = TX+
31 - C2 = TX-
25 - C3 = RX-
23 - C4 = RX+

Channel 1 (this is where I'm not sure)
following numerical order from channel 0
5 - C5 = TX+
3 - C6 = TX-
13 - C7 = RX-
11 - C8 = RX+

or following positional order from above
13 - C7 = TX+
11 - C8 = TX-
5 - C5 = RX-
3 - C6 = RX+

or is it completely different? I've already got an image of channel 0 and plan to block 23, 25, 31 & 33 and run bypass wires for 3, 5, 11 & 13 once I know the correct pinout. Any suggestions?
Image

lcoughey
Site Admin
Posts: 311
Joined: Thu Jan 08, 2015 7:23 pm

Re: Phison mSATA RAID 0 SSD (SSE256GTTCR-S80)

Post by lcoughey » Thu Aug 10, 2017 3:37 pm

Got it figured out.

So, the layout is as follows:

51 [------------------][--------] 1

Channel 0 [33 (TX+), 31 (TX-), 25 (RX-), 23 (RX+)] Channel 1 [13 (RX+), 11 (RX-), 5 (TX-), 3 (TX+)]

Image

lcoughey
Site Admin
Posts: 311
Joined: Thu Jan 08, 2015 7:23 pm

Re: Phison mSATA RAID 0 SSD (SSE256GTTCR-S80)

Post by lcoughey » Mon Aug 14, 2017 1:11 pm

Now that we have a tried and tested solution, we have added the service to our website.

https://www.recoveryforce.com/msata-int ... -recovery/

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests